inspection-fixture base plates, limit blocks and datum-part samples from Chengdu to Germany by air freight: datum-face protection, revision traceability and set positioning

Item boundary for inspection-fixture base plates, limit blocks and datum-part samples

Identify the fixture base, datum references, limit blocks, pins, fasteners and assembly state by drawing revision.

Declare sensors, batteries, cylinders, liquids or magnetic parts if present; an empty mechanical plate is not a complete powered fixture.

The item record must show material, specification, revision, quantity and actual condition, with photographs that resolve ambiguous variants.

Protect datum-face protection, revision traceability and set positioning

Carry the base through verified structural points and shield datum faces, bores and measurement edges from contact.

Place removable blocks and fasteners in revision-coded boxes fixed near—but never rubbing against—the base.

After packing, photograph controlled surfaces, inner positions and carton labels; replace the evidence whenever the arrangement changes.

Evidence check before handover in Chengdu

Trace a sampled datum label through the drawing revision, inner position and protection record before handover.

• Match the physical inspection-fixture base plates, limit blocks and datum-part samples to its exact description and use
• Keep specification, revision, lot, colour, quantity and set links intact
• Document how the package implements datum-face protection, revision traceability and set positioning
• Connect each controlled item to an inner position and carton
• Disclose actual sharp, magnetic, oily, liquid, battery, moving or residual properties
• Measure every completed package rather than a catalogue unit
• Record the Chengdu ready time, handover point and handler
• Confirm the Germany postcode, department, appointment and unloading boundary

Final-package quotation controls

Measure the packed centre of gravity and orientation once all mechanical lockouts and face covers are fitted.

Replacing a block, datum part, sensor or assembly state requires a revised list and fresh photographs.

Capacity, route, customs handling, appointments and last-mile delivery are confirmed against current conditions; a target date remains planning input.

Receipt and evidence in Germany

The German quality laboratory should verify the base revision before uncovering any datum surface.

Freight receipt does not complete calibration, measurement-system analysis, equipment acceptance or production validation.

For damage, shortage or mismatch, preserve the package, labels, inner layout and photographs before sets are mixed or used.

Frequently asked questions