door-handle, hinge and mounting-hardware approval samples from Jiangmen to Italy by air freight: left-right orientation, finish isolation and screw-pack matching

Item boundary for door-handle, hinge and mounting-hardware approval samples

List handles, spindles, roses, hinge leaves, pins and screw packs as separate but linked approval items.

Orientation, hole spacing and finish code must follow the physical set; hydraulic, sprung or lubricated hinges need additional disclosure.

The item record must show material, specification, revision, quantity and actual condition, with photographs that resolve ambiguous variants.

Protect left-right orientation, finish isolation and screw-pack matching

Wrap decorative surfaces with residue-free layers and cap projecting shafts or hinge pins before items share a compartment.

Pair left and right versions with their fastener bags and lock heavy hinges away from slender handles.

After packing, photograph controlled surfaces, inner positions and carton labels; replace the evidence whenever the arrangement changes.

Evidence check before handover in Jiangmen

Use the installation drawing to assemble a paper-level set check, then return every item to its recorded slot.

• Match the physical door-handle, hinge and mounting-hardware approval samples to its exact description and use
• Keep specification, revision, lot, colour, quantity and set links intact
• Document how the package implements left-right orientation, finish isolation and screw-pack matching
• Connect each controlled item to an inner position and carton
• Disclose actual sharp, magnetic, oily, liquid, battery, moving or residual properties
• Measure every completed package rather than a catalogue unit
• Record the Jiangmen ready time, handover point and handler
• Confirm the Italy postcode, department, appointment and unloading boundary

Final-package quotation controls

Take final carton measurements only after face protection, caps and compartment boxes are in place.

Review again when direction, hole spacing, moving mechanism or screw specification changes.

Capacity, route, customs handling, appointments and last-mile delivery are confirmed against current conditions; a target date remains planning input.

Receipt and evidence in Italy

The Italian sample room should check orientation and finish codes before any trial fitting.

Handover does not establish installation fit, hinge endurance, load capacity or building-hardware compliance.

For damage, shortage or mismatch, preserve the package, labels, inner layout and photographs before sets are mixed or used.

Frequently asked questions